More years ago that I care to remember, fellow Caponord owner (Beasthonda) and I discussed the idea of replacing the dashboard LCD panel with an LCD screen that could be made to display just about anything we wanted. At the time, we looked at 4D Systems and made a few notes on feasibility, but in the end the idea fizzled out – primarily because at that time the panels were expensive!
Well here we are, a toe-dip into 2020 and the idea has been resurrected. This in part is due to the panels being better and cheaper now as well as the Arduino boards being much more powerful and faster than the old generation. So as I write, winging it’s way from Australia is an SK-ULCD-35D-AR kit …. basically a 3.5″ non-touch sensitive screen with all the cables and bits to program and connect it to an Arduino device.
The idea is to emulate the existing panel layout for day-to-day riding. However the device will have alternative screens available. The first will be the real-time display of sensor data from the ECU, the second will be a detailed trip computer, displaying continually updated fuel consumption and fuel tank range among other things. The next will display GPS position using a fusion of on-board GPS and Bluetooth mobile link for map downloads.
The display turned up a few days ago. Early the next morning, while the world shivered outside, I managed to program it with a couple of basic screens and power it up for the first time. The displays need to be scaled to fit the aperture in the dash overlay, but other than that it’s pretty much ready to hook up to some data. Role on the weekend!
Swapping over only takes a couple of minutes …. 8xM5 bolts and a click clamp to remove. I exchanged the old one for a nice new Zero-Leak low profile Stainless Steel 11.3mm version – very snug! In fact the old one wasn’t really squashing the pipe onto the siggot anymore and could be pulled/pushed/rotated very easily, which makes me think it was no longer vacuum tight ….hmm. Anyway, the new one crimped up lovely and everything is supper-sealed once again.
I’ve just had a fun few hours preparing the Capo for its MOT (annual inspection) and one of the issues I wanted to get around to sorting was the slightly high tick-over.
As Guinness said, “Good things come to those who wait” …… and boy have I waited! When the new grips went on in late November, they were accompanied by the 3D printed temporary bar-end mounts. The clock was ticking, I had to get the grown-up adult versions (stainless steel!) made up asap as I’d no idea how long these things would hold up. In early January someone stepped in to do the deed.
So just when I was giving up on ever seeing a set, a mate offered to help, and in the blink of an eye made these beauties! They fit perfectly and the finish is brilliant – what more can I ask for? So a huge ‘Thank you’ goes out to Jason – stand up, take a bow, don’t be shy fella! The eagle-eyed will notice a change from the rendering (and drawing) in that the flats (for socket or spanner) were left off. This was to reduce machining time and also because they only really need to pinch up – I’m not torquing the nuts off an axle here!
As I rolled off the bottom of Stokenchurch hill with a clear motorway ahead and a remaining journey time of 15 minutes, it was time for a little post-ride reflection. The dashboard temp gauge dropped another degree and sat at 5C – hardly the 20C at midnight when I’d left Italy 19hrs previously! Never mind, the Oxford heated grips were doing their thing, keeping my podgy fingers nice and toasty in my BKS winter gloves. From the front of the bike, the white beams of the Sealight X2 LED’s turned night into day – from hard shoulder to armco barrier a reassuring spread of light paved the way.
reset the trip and ride up to a mileage above which you know you’ll be pushing – and repeat! Happy days ….