INNOVV K2 – a quick update

OK, so this is a no-frills post while I’m on the road in Italy …..

Some folks have asked how the INNOVV K2 is getting along after I fitted it to the Capo a few weeks ago. Well here is a quick update for you! The install is a semi-permanent arrangement – the recording unit and GPS module are in the under-seat storage area and the front camera is hung from the right-hand fog lamp, while the rear camera hangs from the right-hand pannier rail. Both are very much temporary mounts and as such suffer from a little vibration (front mostly) but it’s only noticeable at certain RPM’s. This will disappear once they are mounted permanently on more robust mounts.

The 12v/5v power supply sits in the same spot as the old unit – on top of the ECU. 12v is taken directly from the battery and the sensing/switching connection goes to the tail lights. No lights, no cameras!

The system has run faultlessly from day 1. Start the bike, turn on the lights and away it goes …. no fuss, no drama. I have not experienced any of the shortcomings of the old K1 – corrupt files, frozen recording etc. The K2 has done its job exactly as it should, in fact I’ve got so comfortable with it that I no longer check the video or setting on the app every ride …. I just fire up and go! At the end of the week I’ve checked the SD card and been really pleased that all the files are recorded just fine with no corrupt or dropped frames in sight.

So that’s it as far as a quick update is concerned. Once I’m back in the UK I’ll go more in detail about image quality etc, but for now I’m really pleased with the K2, it’s a real improvement over the K1 in all aspects. 

This entry was posted in Uncategorized and tagged , , , , , , . Bookmark the permalink.